JBL CLIP 4
|Output power (W)||5|
|Frequency Range Hz (-10 dB)||2400 – 2483.5MHz|
|Dynamic frequency response range (Hz)||100Hz-20kHz|
|Dimensions (in)||3.4 x 5.3 x 1.8”|
Control Connect Specifications
|Bluetooth profiles||A2DP 1.3, AVRCP 1.6|
|Bluetooth transmitted modulation||GFSK, π/4 DQPSK, 8DPSK|
|Bluetooth transmitter power||≤ 10 dBm (EIRP|
Documents & Downloads
Quick Start Guide
What’s in the Box
- 1 x JBL Clip 4
- 1 x Type C USB cable
- 1 x Quick start guide
- 1 x Warranty card
- 1 x Safety sheet
FAQs & How-Tos
Playback TimeThis product supports up to 10 hours of audio playtime. Please note that battery life may vary depending on volume level and content.
Connect Feature Information
This product is not supported by Connect + or Partyboost on the JBL Portable app. They cannot connect to other portable speakers wirelessly.
Does my Speaker have Speakerphone/Voice Assistant Functionality?This product does not feature speakerphone or voice assistant functionality as it does not have a microphone.
How to Factory Reset JBL Clip 3 & 4In Power On mode, press and hold 'Volume+' together with 'Play/Pause' for more than 2 seconds on the Clip 3 or for more than 10 seconds on the Clip 4. The speaker will power off and is now reset.
Does this speaker have an Aux Input?This speaker does not have an Aux Input, so no analog connection is possible.
IP67 InformationThis product is rated IPX67 which is different from IPX7. IP67 protects the product from submersion in 1 meter (3.3 feet) of water for up to 30 minutes, but it is also resistant against dust. Dust accumulation around electronics can lead to hardware failure so the IP67 rating is extremely beneficial addition to this product.
My device is waterproof, but what about salt water or chlorine water?
Your JBL speaker is waterproof with IPX7 rating. (IPX7 means it can survive immersion in 1 meter/3.3 feet for up to 30 minutes.) To maintain the looks and functions of your speaker, please make sure to rinse it with fresh water after using it at a swimming pool or the ocean, then dry off all covers and areas where water can gather. The standard for waterproofing is for tap water. Chemicals and salt in your pool or the ocean can damage the waterproof seals or harm the surface finish over time if not rinsed off after use.
Can’t find what you’re looking for?
Talk to a product expert
Call us now at: (800) 336-4525
Mon - Fri: 9:00 am - 11:00 pm (EST)
Sat - Sun: 9:00 am - 5:00 pm (EST)
Chat With Us
Mon - Fri - 9:00 a.m 11:00 p.m (E.T)
Sat - Sun - 9:00 a.m 5:00 p.m (E.T)