|Ear tip material||Silicon|
|Headphone cable length (cm)||55.5|
|Headphone cable length (ft)||1.8|
|Driver size (mm)||8.0|
|Driver sensitivity at 1kHz/1mW (dB)||102dB|
|Dynamic frequency response range (Hz)||20 Hz - 20 kHz|
|Number of drivers per ear||1.0|
Control Connect Specifications
|Bluetooth profiles||HFP v1.6, HSP v1.1, A2DP v1.2, AVRCP v1.5|
|Bluetooth transmitted modulation||GFSK, π/4DQPSK, 8DPSK|
|Bluetooth transmitter power||0-4 dbm|
Documents & Downloads
Quick Start Guide
What’s in the Box
- 1 Pair of JBL E25BT Headphones
- 1 Charging Cable
- Warning Card
- Warranty Card
- Safety Sheet
- Carrying Pouch
FAQs & How-Tos
Can I listen to music while I am charging my E25BT headphones?
Unfortunately, you cannot turn on and use the headphones while they are charging.
Can I take phone calls with the E25BT headphone?
Yes, the E25BT features a three button microphone which enables you to pause/play, skip tracks and answer and hang up phone calls.
How many hours can I receive on a full charge?
You should expect up to 8 hours of playback time on a fully charged battery.
How do you power on and pair the E25BT Headphones?
Make sure that the device you want to connect to is on and in pairing mode. Press and hold the center button on the inline microphone for 3-5 seconds. (We recommend putting one ear tip inside your ear to hear the audio prompt) You should here "powering on.....pairing" as it searches for your device. The E25BT headphone should appear on your discoverable devices and should connect within 2-3 seconds. If you wish to pair to a different device, make sure the last device it was connected to has the bluetooth turned off. Make sure the headphones are off and press and hold the center button between 3-5 seconds or until the audio prompt states that it is "looking for device" You should be able to pair with a different device within 2-3 seconds.
E25BT Headphones: Battery Life
It typically takes 2 hours to reach the maximum battery life depending on the voltage which varies from 110 volts or 120 volts.
Are these headphones sweat proof?
Unfortunately if these headphones are overexposed to sweat or water, it may compromise the controls or sound quality.
Is it possible to turn off the blinking blue LED light from my headphones?
No. There is no way to turn off the blue LED light from our wireless headphones unless they are turned off.
How can I reset my JBL E25BT?
You can reset the E25BT in two ways: 1: Press and hold Volume + and Volume - simultaneously for more than 3 seconds. This resets to factory settings, clearing the pairing list. 2: With unit in ON mode, plug in the USB cable. This resets the unit and puts it into charging mode.
Can’t find what you’re looking for?
Talk to a product expert
Call us now at: (800) 336-4525
Mon - Fri: 9:00 am - 11:00 pm (EST)
Sat - Sun: 9:00 am - 5:00 pm (EST)
Chat With Us
Mon - Fri - 9:00 a.m 11:00 p.m (E.T)
Sat - Sun - 9:00 a.m 5:00 p.m (E.T)