JBL Go 3
|Dynamisk frekvensområde (Hz)||110 Hz - 20 kHz|
|Mål (inch)||3.4 x 2.7 x 1.6|
|Mål (cm)||8.6 x 6.9 x 4.0|
Control Connect Specifications
|Bluetooth-profiler||A2DP 1.3, AVRCP 1.6|
|Bluetooth-frekvens||2402 MHz − 2480 MHz|
|Bluetooth sender-modulation||GFSK, π/4 DQPSK, 8DPSK|
|Bluetooth sender-effekt||≤ 8 dBm (EIRP)|
Documents & Downloads
What’s in the Box
- 1 x JBL Go 3
- 1 x type C USB-kabel
- 1 x lynstartguide
- 1 x garantikort
- 1 x sikkerhedsark
FAQs & How-Tos
Power on the speaker, then press and hold the Volume + button and Bluetooth button together for 3-5 seconds until the speaker turns off.
Once turned off, the speaker has been reset to the factory default settings.
• Try to shutdown other products that have Bluetooth, but are not being used. They are often the reason for interference even though they are not being used.
• Do not stand too close to your Wi-Fi router since a Wi-Fi signal is stronger and in many cases will "overlap" the connection.
• Be aware of walls around you. Concrete and brick walls will often interrupt the signal, as it cannot pass through such thick walls.
• Bluetooth signals cannot travel through water, which includes the human body. Make sure with wireless headphones to keep your source device and the receiver on the same side of your body.
• Open spaces such as parks can cause issues for your devices, as open air is "bad" for any Bluetooth signal if it cannot reflect from objects around you.
The difference is that the new ECO versions of Go 3 and Clip 4 are made from 90% PCR (Post-Consumer Recycled) plastic and wrapped in 100% recycled fabric on the speaker grille, while still delivering the same rich JBL Original Pro Sound and significantly reducing the carbon footprint of the product.
It is always recommended to use our range of Soundbars if you want a speaker for your Television or Smart TV as they are designed specifically for this purpose, whereas our Portable speakers are designed primarily for use with Phones and Tablets.
Support for Bluetooth connectivity between a TV and speaker depends on a number of different factors such as Bluetooth & A2DP versions and Audio Codecs used by each device. This can vary based on the brand, model and age of the devices, however we cannot confirm if any specific combination of TV and speaker will work without issues such as latency or lip sync delay.