Support Overview / Car & Marine / Car Electronics / Amplifiers / Amplifiers (4-channel) / GX-A604

GX-A604

4-kanals forstærker

Sold from 2013 until 2014

Getting started with your GX-A604

Quick Start Guide & Downloads

Manuals

Betjeningsvejledning (Engelsk) 1.78 MB

Product Specifications

Specifikationer

Number of Channels: 4 channels

Number Of Channels: 4 Channels

Amplifier Power (RMS): 4 ohm... 60W x 4, <1% THD+N

Power Handling (peak): 435W

Signal-to-Noise Ratio: 93dB

Frequency Response: 20Hz – 20kHz

Total Harmonic Distortion: <1%

Input Sensitivity: 200mV-20V

Variable Bass Boost: 0 to + 12dB @ 45Hz

MSRP U.S.: $179.95 each

Lydspecifikationer

Signal-to-Noise Ratio: 93dB

Total Peak Power Output: 435W

THD + N: ;less than 1%

Frequency Response: 20Hz-20kHz

Input Sensitivity: 20mV-20V

Bridged Power Output: 170W x 2 into 4 ohms

4-Ohm Power Output: 60 Watts RMS x 4 channels

Variable Bass Boost: 0 to + 12dB @45Hz

2-Ohm Power Output: 85 Watts RMS x 4 channels

Mål

Width (in): 8-1/8

Depth (mm): 300

Height (mm): 52

Depth (in): 11-13/16

Width (mm): 206

Height (in): 2-1/16

Dimensions (H x W x D): 2-1/16 inch x 8-1/8 inch x 11-13/16 inch (52mm x 206mm x 300mm)

Powerful and Compact 435-Watt Amplifier

GX-A604 er et 4-kanals kraftværk på 435 watt – med indbygget elektroniske delefiltre og equalizer for variabel bas på bagkanalerne – et rendyrket og alsidigt system. Med al den kraft, der er indeholdt i en 2-1/16" (52 mm) høj, 8-1/8" (206 mm) bred og 11 13/16" (300 mm) dyb pakke, er GX-A604 nem at installere og kan stadig fungere som grundlaget for et ægte sofistikeret lydsystem. Har køleprofiler i støbt aluminium, indbygget elektronisk delefilterkredsløb og kontakt til bas-boost.

Equipped with both low-level and high-level inputs

The GX-A604 is equipped with both low-level and high-level inputs, allowing conncetion to virtually any factory or aftermarket head unit. Low-level input is made via standard RCA connectors and high-level inputs made via a supplied Molex connector and harness.

Electronic crossover

The 12dB per octave electronic crossover is fixed at 80Hz and can be selected either high-pass or low-pass. This allows the GX-A602 can be used as a an amplifeir to drive full-range speakers or as a subwoofer amplifier.

Bass Boost circuit

The GX-A602 also has an switchable bass boost circuit on the rear channels that adds a fixed at 45Hz and will provide+12dB of gain.

FAQs & How-Tos

1 results

Sort

Page size

In the owner's manual, the trigger input is described as "optional". But without a trigger cable, it seems impossible to switch the amplifier on and off. How come?

The amplifier has a signal sensor on the high-level (speaker level) inputs, so it is not necessary to use a trigger cable when input is high-level, and connected to the high-level inputs. However, low-level input signals through the RCA-phone input sockets do not activate a signal sensor, so use of a trigger cable is MANDATORY for low-level input signal use.

Was this helpful? Thank you for your feedback!