JBL Tune Flex Ghost Edition
|Driver size (mm)||12|
|Number of Microphones||4|
|Driver sensitivity at 1kHz/1mW (dB)||110|
|Dynamic frequency response range (Hz)||20 Hz – 20 kHz|
|Charging Case Weight (oz)||1.4|
|Earpiece Weight (oz)||0.3|
|Lade-etuiets vekt (g)||38.6|
|Øreproppens vekt (g)||9.6|
Control Connect Specifications
|Bluetooth profiles||A2DP V1.3, AVRCP V1.6, HFP V1.7|
|Bluetooth frequency||2.4 GHz - 2.4835 GHz|
|Bluetooth transmitted modulation||GFSK, π/4-DQPSK, 8DPSK|
Documents & Downloads
What’s in the Box
- 1 x JBL Tune Flex hodetelefoner
- 1 x ladeetui
- 1 x USB Type-C-ladekabel
- 1 x åpen ørepropp
- Forseglende ørepropper i 1 x 3 størrelser
- 1 x garanti/advarsel (W/!)
- 1 x hurtigstartveiledning/sikkerhetsdatablad (S/i)
FAQs & How-Tos
If you are experiencing volume or balance issues, always check for wax and dirt in and around the earbud and driver and complete cleaning of the earbuds as described above. If the issue persists, there may be earwax/dirt stuck in the small holes in the grille in front of the driver, preventing sound output. To resolve the issue try dipping the affected earbud tip into a solution of lukewarm tap water and a small amount of dish soap (washing up liquid). The earbud tip should only be put into the liquid up to a maximum depth of 1-2 mm only (see images below). Immersing the earbuds in water or putting the earbuds in water at a larger depth than this could void your warranty. Keep the earbud tip in the water for about 2-3 minutes, then wipe/clean the grille with a small brush (such as a toothbrush). This should remove the wax and resolve the volume/balance issues.
If you have charging problems, the first step is to always clean all contact points, on each earbud and on the charging case.
You will need: cotton cloth or makeup swab, cotton swabs and rubbing alcohol. Also a pencil with eraser for further cleaning.
Use a cotton swab with some rubbing alcohol to clean the charging terminals of the headphones. Rotate the swab and scrub lightly on each contact surface, then use a cotton cloth to remove any dust and cotton residue left on the headphones. It is important to perform this process periodically to keep your headphones clean, thus avoiding affecting the charging speed/quality.
Wipe the contact pins in the charging case with a clean cotton swab. The swab can be slightly moistened with rubbing alcohol, but it is important that the interior is completely dry before closing the box. Use the cotton cloth and wait for it to dry.
Repeat until the contact points are visibly clean, and charging should work as designed.
Try cleaning the contacts with the tip of a pencil and the eraser at the end of the pencil, the graphite and rubber can help to re-establish charging also.
This procedure can be performed on all TWS earphones and cases.
This restores the earbuds to the factory defaults.
TWS must be connected to perform the reset, so neither of the earbuds should be off or in the charging case.
It also may be necessary to remove or forget the earbuds from the list of paired Bluetooth devices in order to pair again.