P963

P963

330-watt, three-way, 6" x 9" speakers

Såld från 2008 tills nu

Föregående produkt: POWER P953
Tillverkade i: China

Komma igång med din $produkt

Product Registration

Registrera din produkt

Äger du den här produkten? Registrera dig här! Och gör anspråk på din garanti eller service på ett enkelt sätt

Registrera nu

Dokument och hämtningar

Produktspecifikationer

Type
Three-Way
Size
6 x 9
Series
Power Series
Nominal Impedance
2 ohms
Power Handling (Peak)
330W
Frequency Response
35Hz–23kHz
Power Handling (RMS)
110W
Sensitivity
(2.83V@1m) 96dB
External Diameter (mm)
234.5
Mounting Cutout Diameter (in)
8-3/4
Mounting Depth (in)
3-1/4
Mounting Cutout Diameter (mm)
222
External Diameter (in)
9-1/4
Mounting Depth (mm)
82.5
Low-Frequency Transducer
PlusOne® HCL™ honeycomb-laminate cone
Crossover Frequencies
Outboard
High-Frequency Transducer
25mm (1") edge-driven textile dome
Ultra High Frequency Transducer
22mm (7/8") edge-driven textile dome
Controls/Adjustments
UHF cut: 0dB/-3dB

6 inch x 9 inch 3-Way Loudspeaker with Plus One HCL woofer cone and high-bandwidth edge-driven textile dome tweeter and super tweeter

The Plus One® Honeycomb-Laminate™ woofer cone is exceptionally stiff and lightweight with up to 25 percent more active surface area than a standard one of the same size. With a long-excursion surround, it boosts bass output and efficiency by 2 to 3 decibels compared with others.
It’s not the miniature tweeters that most other manufacturers use, but a high-bandwidth, edge-driven textile-dome tweeter like those found in very high-end home audio loudspeakers. Crank it up. You get less distortion even at high volumes and superior integration with the midwoofer.
These speakers make the best use of any amplifier by providing an optimum 2-ohm load. They use a lower-impedance voice coil than a typical speaker to extract the most power and performance possible from all amplifiers engineered to drive loads of 4 ohms or less. And the spider integrated, stitched-in tinsel gives the speaker enhanced reliability and eliminates audible tinsel-lead slap.
The JBL® P963 has a tweeter-level control. Use the simple switch to set the tweeter output level to match your personal listening preference or different mounting locations.
You’ll have 110 watts RMS and 330 watts peak power handling and a 96dB sensitivity rating. And you can push them to the limit. You’ll hear true JBL® sound. Nothing is under- or over-emphasized. The P662 has a frequency response of 35Hz to 23kHz.
In addition to better sound quality, the new, proprietary, JBL-patented woofer design offers far higher SPL (Sound Pressure Level) and better suspension symmetry than the previous generation.
Outboard crossovers are integrated into a harness connected to each speaker for easy installation. Oversized Direct-Connect terminals ensure perfect connectivity for bare speaker wires.

Hittade du inte det du sökte efter?

Ring oss

Ring oss

Ring oss på: +46 850512632

Måndag – fredag: 09:00-17:00

Skicka e-post till oss

Skicka e-post till oss

Vi är här måndag-fredag för att svara på ditt mejl så fort vi kan!

Skicka e-post till oss
Chatta med oss

Chatta med oss

Chatta på engelska:
Måndag – fredag: 09:00-18:00
Lördag – söndag: 10:00-16:00

message

WhatsApp oss

WhatsApp-support endast på engelska

Skicka ett meddelande till oss på engelska här 

Måndag – fredag: 09.00-18.00
Lördag – söndag: 10:00-16:00