P562
165-watt, two-way, 5-1/4" speakers
Såld från 2008 tills nu
| Föregående produkt: | POWER P552 |
|---|---|
| Tillverkade i: | China |
Komma igång med din $produkt
Registrera din produkt
Äger du den här produkten? Registrera dig här! Och gör anspråk på din garanti eller service på ett enkelt sätt
Registrera nuDokument och hämtningar
Produktspecifikationer
- Series
- Power Series
- Type
- Two-Way
- Size
- 5-1/4
- Sensitivity
- (2.83V@1m) 92dB
- Power Handling (RMS)
- 55W
- Nominal Impedance
- 2 ohms
- Power Handling (Peak)
- 165W
- Frequency Response
- 55Hz – 23kHz
- Mounting Depth (in)
- 2-1/16
- External Diameter Woofer (in)
- 5-1/8
- External Diameter Woofer (mm)
- 130
- External Diameter (in)
- 5-1/8
- External Diameter (mm)
- 130
- Mounting Depth (mm)
- 52.5
- Mounting Cutout Diameter (mm)
- 120
- External Diameter Tweeter (mm)
- 51.6
- Mounting Cutout Diameter (in)
- 4-3/4
- External Diameter Tweeter (in)
- 2-1/16
5-1/4 inch 2-Way Loudspeaker with Plus One HCL woofer cone and high-bandwidth edge-driven textile dome tweeter
The Plus One® Honeycomb-Laminate™ woofer cone is exceptionally stiff and lightweight, with up to 25 percent more active surface area than a standard one of the same size. With a long-excursion surround, it boosts bass output and efficiency by 2 to 3 decibels compared with others.
It’s not the miniatures that most others use, but a high-bandwidth, edge-driven textile-dome tweeter like those found in very high-end home audio loudspeakers. Crank it up. You get less distortion even at high volumes and superior integration with the woofer.
Another JBL feat of engineering: the P562 features a tweeter mounted on a 15-degree angle. You can rotate it nearly 360 degrees to aim it at the listening position for improved high-frequency response.
The JBL® P562 has tweeter-level control. Use the simple switch to set the tweeter output level to match your personal listening preference or different mounting locations.
You’ll have 55 watts RMS and 165 watts peak power handing and 92dB sensitivity. And push them to the limit. You’ll hear true JBL® sound, nothing is under- or over-emphasized. The P562 has a frequency response of 55Hz to 23kHz.
In addition to better sound quality, the new, proprietary, JBL-patented woofer design offers far higher SPL (sound pressure level) and better suspension symmetry for lower distortion than the previous generation.
These speakers make the best use of any amplifier by providing an optimum 2-ohm load. They use a lower-impedance voice coil than a typical speaker to extract the most power and performance possible from all amplifiers engineered to drive loads of 4 ohms or less.
Outboard crossovers are integrated into a harness connected to each speaker for easy installation. Oversized Direct-Connect terminals ensure perfect connectivity for bare speaker wires.
Bilder och videor
Hittade du inte det du sökte efter?
Skicka e-post till oss
Vi är här måndag-fredag för att svara på ditt mejl så fort vi kan!
Skicka e-post till oss
Chatta med oss
Chatta på engelska:
Måndag – fredag: 09:00-18:00
Lördag – söndag: 10:00-16:00
WhatsApp oss
WhatsApp-support endast på engelskaSkicka ett meddelande till oss på engelska här
Måndag – fredag: 09.00-18.00Lördag – söndag: 10:00-16:00