P662s
165-watt, two-way, shallow-mount, 6-1/2" speakers
Sold from 2008 until now
| Predecessor Product: | POWER P652S |
|---|---|
| Made in: | China |
Getting started with your P662s
Register your product
Do you own this product? Register it here! And claim your warranty or service easily
Register nowDocuments & Downloads
Product Specifications
- Series
- Power Series
- Size
- 6-1/2
- Type
- Two-Way
- Sensitivity
- (2.83V@1m) 93dB
- Power Handling (Peak)
- 165W
- Frequency Response
- 55Hz-23Hz
- Nominal Impedance
- 2 ohms
- Power Handling (RMS)
- 55W
- Mounting Cutout Diameter (in)
- 5-1/6
- Mounting Cutout Diameter (mm)
- 128.6
- External Diameter (in)
- 6-1/4
- External Diameter (mm)
- 158.2
- Ultra High Frequency Transducer
- High-bandwidth, edge-driven, textile-dome tweeter
6-1/2 inch 2-Way Shallow-Mount Loudspeaker with Plus One HCL woofer cone and high-bandwidth edge-driven textile dome tweeter
The Plus One® Honeycomb-Laminate™ woofer cone is exceptionally stiff and lightweight, with up to 25 percent more active surface area than a standard one of the same size. With a long-excursion surround, it boosts bass output and efficiency by 2 to 3 decibels compared with others.
It’s not the miniatures that most others use, but a high-bandwidth, edge-driven textile-dome tweeter like those found in very high-end home audio loudspeakers. Crank it up. You get less distortion even at high volumes and superior integration with the woofer.
The JBL® P662s has tweeter-level control. Use the simple switch to set the tweeter output level to match your personal listening preference, or different mounting locations.
You’ll have 55 watts RMS and 165 watts peak power handing. And push them to the limit. You’ll hear true JBL® sound, with nothing under- or over-emphasized. The P662s has a frequency response of 45Hz to 23kHz.
In addition to better sound quality, the new, proprietary, JBL-patented woofer design offers far higher SPL (sound pressure level) and better suspension symmetry for lower distortion than the previous generation.
These speakers make the best use of any amplifier by providing an optimum 2-ohm load. They use a lower-impedance voice coil than a typical speaker to extract the most power and performance possible from all amplifiers engineered to drive loads of 4 ohms or less.
Outboard crossovers are integrated into a harness connected to each speaker for easy installation. Oversized Direct-Connect terminals ensure perfect connectivity for bare speaker wires.
Images & Videos
Can’t find what you’re looking for?
Call Us
Talk to a product expert
Call us now at:
021-42871228
Jakarta: 021-26538568 Extension 1290/1292
Bandung: 022-4215995
Surabaya: 031-5355111
Makassar: 0411-448381
Bali: 0361-499048, 0361-499035
Mon - Fri - 9:00 a.m 5:00 p.m
Sat: 9:00 a.m 1:00 p.m