MA 6004

MA 6004

4-Channel Full-Range Marine Amplifier (60x4)

Vendido desde 2006 hasta ahora

Hecho en: China

Empezando con su MA 6004

Product Registration

Registre su producto

¿Es propietario de este producto? ¡Regístrelo aquí! Y reclame su garantía o servicio fácilmente

Regístrese ahora

Documentos y descargas

Especificaciones del producto

Amplifier Power (RMS)
60 watts x 4 channel @ 4 ohms and ≤1% THD + N
Signal-to-Noise Ratio
86dBA (reference 1 watts into 4 ohms)
Dynamic Power
145 watts @ 2 ohms
Effective Damping Factor
6.39 @ 4 ohms
Frequency Response
10Hz – 27kHz (-3dB)
Maximum Input Signal
Input Sensitivity
MAXIMUM... 100mV
$169.95 each
Input Sensitivity
Signal-to-Noise Ratio
Damping Factor
6.395 at 4 ohms
Dynamic Power Output
145W at 2 ohms
2.2 inch x 13 inch x 10.3 inch

4-Channel Full-Range Marine Amplifier with electronic crossover, variable bass bosst and preamp outputs.

With a marinized circuit board, stainless-steel hardware and all the right waterproofing, the MA6004 is, like all JBL® marine audio products, built to survive salt water, corrosion and other risks – and show you a great time out on the water.
The JBL® MA6004 has onboard 12dB electronic crossovers, giving you tuning options for systems of any size. Versatility, convenience and ease of use are all part of the JBL way of sound.
Your boat may give you a choice of where to install your sound system, or it may not. Fortunately, the MA6004’s variable bass-boost circuit provides additional bass tuning to optimize performance, regardless of where it lives.
Owning a boat takes commitment and work. Installing the JBL® MA6004? Not so much. It’s also pretty compact at 13-1/4" x 10-1/4" x 2-3/16" (337mm x 261mm x 56mm) with a low-profile heatsink. You can put it in some very tight spots.
The JBL® MA6004 has output of 60 watts RMS X 4 channels at 4 ohms. You can fill the fresh, open air with great sound.
The MA6004 comes equipped with a separate 12dB Per Octive Electronic Crossover for front and rear channels. This provides a high level of tunablity and allows for different speakers to be connected to the front channels and rear channels. Both crossovers are setep to allow for either high-pass or low-pass.
The front and rear channels are also equipped with a separatae variable bass boost for the front channels and rear channels. There is a total of 6dB of boost available centered at 45Hz.
The MA6004 has a preamp output which allows a full range signal to be passed on to additional amplifiers.

¿No encuentras lo que buscas?



Habla con un experto sobre nuestros productos
Llámanos a este número: 50223141399

Lunes - Viernes: 09:00 AM -06:00 PM (Hora Centro)

Envíanos un correo electrónico

Envíanos un correo electrónico

¡Estamos aquí de lunes a viernes para responder sus correos lo antes posible!

Envíanos un correo electrónico