JBL Horizon 2 FM
|Output power (W)||2x5W RMS|
|Dynamic frequency response range (Hz)||75Hz–20KHz (-6dB)|
|Dimensions (in)||7.0" x 6.4" x 3.0"|
Control Connect Specifications
Documents & Downloads
Quick Start Guide
What’s in the Box
- 1 x Horizon 2
- 1 x Adaptor
- 1 x Pig-tail Antenna
- 1 x Quick-Start Guide
- 1 x Safety Sheet
- 1 x Warranty Card
FAQs & How-Tos
You must first set a radio preset by tuning to a radio station and holding down the 1, 2, or 3 button to save it. After this, the preset will be an option when setting up a new alarm.
When setting up the alarm, the options will be displayed in the following order:
1. Set Alarm Hour.
2. Set Alarm Minute.
3. Set Recurrence - Weekday/Once.
4. Set Ringtone - 4 built-in alarm tones or radio preset 1/2/3 (see information above).
5. Set Light - On/Off.
If the light is set to 'On' when the alarm is set up, once it goes off it will gradually increase in brightness over 10 seconds.
This works in the order (from standby/off): DAB / FM / Off.
In Bluetooth mode, if the phone or tablet is disconnected, or nothing is played for 10 minutes, the Horizon 2 will go into standby mode automatically (not changeable).
If the screen appears dark, try repositioning the Horizon 2 for the light sensor to work to the fullest. In some positions, the Horizon 2 cannot effectively detect the ambient light level in the room.
On backup battery power, please wait 50 seconds for the alarm to turn off automatically.
The duration of the snooze cannot be changed and is fixed to 9 minutes. The alarm will continue to ring for 3 minutes and if not turned off or snoozed, it will automatically snooze after this time. It will automatically snooze for a maximum of 3 times, but if the snooze button is used before this occurs, the alarm can be snoozed an unlimited number of times.
Once snoozed, the display shows the time that the alarm will next ring.
To keep the radio playing after the alarm is turned off, press one of the 3 preset buttons or the DAB/FM button as desired.
Please note: the alarm volume will gradually increase until you choose to either snooze or turn the alarm off completely.
On the bottom panel, rotate the battery cover into the unlocked position and remove the cover. Press the battery clip visible on the back side of the battery compartment to allow the existing battery to come out. Then insert the new battery in the slot with the + side visible (facing up), and install the battery cover again. Rotate the battery cover to lock it into place.
Can’t find what you’re looking for?
Talk to a product expert
Call us now at: (800) 336-4525
Mon - Fri: 9:00 am - 11:00 pm (EST)
Sat - Sun: 9:00 am - 5:00 pm (EST)
Chat With Us
Mon - Fri - 9:00 a.m 11:00 p.m (E.T)
Sat - Sun - 9:00 a.m 5:00 p.m (E.T)