How To

How To

1217 results
  • Yes, the JBL Duet Mini features a three button microphone which enables you to pause/play, skip tracks and answer and hang up phone calls.
  • Yes, the E25BT features a three button microphone which enables you to pause/play, skip tracks and answer and hang up phone calls.
  • Yes, although this is not mentioned in the owner's manual, it can be done by pressing and holding the light effect button for more than two seconds.
  • No. These headphones are not waterproof. Swimming with these headphones will cause significant and irreversible damage.
  • You should not submerge the speaker into any water or liquid.
  • Yes. The Google cast function works independent to that of Bluetooth, therefore you are able to Bluetooth connect to another device while casting audio to the JBL Playlist simultaneously. This feature is applicable on smartphones, tablets/iPad, and Bluetooth capable computers.
  • Yes, Control Xstream is a Chromecast device that allows you to cast music content via your Chrome browser. However, the JBL Control Xstream is not made for video purposes, because there will be delay between sound and image.
  • Yes, the E45BT headphones also have an detachable audio cable that you can plug into the headphones. The plug is located at the bottom of the right ear cup.
  • You can only share the sound via JBL Connect through Bluetooth connected devices. TV sound is not permitted as it would cause lip-sync issues.
  • Yes it is possible to reset your speaker. The reset will remove all Bluetooth pairings and WiFi network settings. In power ON mode, press and hold the Power Button for at least 10 seconds, until the volume and input selector lights begin to flash. Your JBL Authentics L8 or L16, are now back to factory settings. Please reconnect the speaker to your WiFi network again.
  • Yes, on the master speaker (the one with playback buttons), simply press the Reverse and Forward Play buttons at the same time for 3 seconds. Please note that after you have performed the reset procedure, master and secondary speakers are no longer connected. Go to the owner's manual page 4, the section "speaker association", to pair the secondary and master again.
  • No, the pads are glued to the headphone body, and must be replaced by a service technician.
  • Yes, the ear pads are replaceable by owner. The pads can be purchased as spare parts from the service center, or purchased directly from the JBL spare parts web shop, when opened.
  • It is possible to replace the ear pads, but there are details to consider. On Elite 700: The ear pads are held in place by a plastic plate with claws, and some of the claws will most likely break off when you remove the pad. You do this by grabbing under the edge where the fabric ends, then pulling hard outward. The claws will eventually let go, and some of them will break off, rattling inside the ear pod. The only way to get them out is to unscrew the speaker plate, lift it up, and shake out the broken-off claws. The new pads are simply centered over the speaker plate, and the claws pressed into the holes with a firm pressure. On Everest 700: The ear pads are glued into position with double-adhesive tape. Pull the old pads off with a forceful, steady pull, until the glue lets go. Remove the protective layer on the new pads, and carefully position them correctly before pressing home all the way around the edge.
  • Yes, use the MONITOR OUT sockets (1/4” and RCA are available on 208P, RCA on ONE) to feed into a recording device. Please note that these outputs are volume controlled, so set the volume correctly, depending on the sensitivity of the recording device.
  • Yes. Out-the-box the JBL Bar series soundbar recognizes volume and mute controls from the most common TV remote controls. The JBL Bar series has IR learning. You can use this feature to teach the soundbar to response to your TV's remote control as well.
  • Yes, you can play game either wired or wirelessly while using USB-C charging cable.  
  • Yes, you can use them for telephone conversations in both Bluetooth and wired mode when paired with a smart device. 
  • Yes, steam and drops of water in a bathroom are fine.
  • Yes, steam and drops of water in a bathroom are fine.
  • Yes, these headphones can be connected and paired to two devices at the same time.
  • Speakers are associated with each other from the factory. If one of them fails, and you get a replacement, then you will need to follow the association section in the owner's manual, so you can pair your new speaker with the one you have. We do not recommend doing this to mix differently colored speakers, only if one of them becomes defective.
  • Unfortunately, you cannot turn on and use the headphones while they are charging.
  • Yes, but only via cabled connection. When you insert the USB charging cable, Bluetooth is switched off, so wireless listening is not possible.
  • Yes, but only via cabled connection. When you insert the USB charging cable, Bluetooth is switched off, so wireless listening is not possible.
  • Yes, but only via cabled connection. When you insert the USB charging cable, Bluetooth is switched off, so wireless listening is not possible.
  • Yes, you can listen to music via cabled connection while you charge the battery. As soon as you insert the charging cable, all active circuits are switched off, and only the analog cable input remains active. When charging has finished, you can use the wireless and noise cancelling functions again.
  • Yes, you can listen to lossless audio from your speaker.

    If you own a Flip 7 or Charge 6, then make sure software version 1.9.0.1 or later is installed via the JBL Portable app.

    You will then be able to enjoy lossless audio through a USB cable connection to your laptop or tablet.

     

    Follow these steps to enable USB audio playback:

     

    a. Enter USB Audio Playback mode

    Connect a USB-C cable to the speaker.

    Press and hold the "Play" button on the speaker, you'll hear a confirmation tone when USB Audio Playback mode is activated.

    b. Revert to Bluetooth mode

    The speaker will automatically switch back to Bluetooth mode when the USB cable is disconnected from the USB port.

    c. Re-enter USB Audio Playback mode

    To switch back to USB Audio Playback mode, reconnect the USB-C cable and repeat the steps.

     

    A USB type A-C or type C-C shorter than 1,2m is recommended for optimal performance.

    USB thumb drive playback is not supported.

  • We only offer volume+ and volume-, mute and power for your TV remote to learn these IR codes.
  • In most cases there would not be room for this driver under a car seat. But there is a under seat model.
< 1 ... 35 36 37 38 39 ... 41 >

Can’t find what you’re looking for?

Call Us

Call Us

Talk to a support agent
Call us now at: (800) 336-4525

Mon - Fri: 9:00 am - 11:00 pm (ET)
Sat - Sun: 9:00 am - 5:00 pm (ET)

Chat With Us

Chat With Us

Mon - Fri: 9:00 am - 11:00 pm (ET)
Sat - Sun: 9:00 am - 5:00 pm (ET)

message

Text Us

Text with a support agent via SMS at:
628-333-7807

Mon - Fri: 9:00 am - 11:00 pm (ET)
Sat - Sun: 9:00 am - 5:00 pm (ET)