


JBL Jr310
Product Specifications
Audio Specifications
Frequency response | 20Hz – 20kHz |
---|---|
Impedance | 32 ohm |
Sensitivity | 80dB SPL @ 1kHz/1mW |
Maximum SPL | 80dB |
Microphone sensitivity | -40 ± 3dVB @1kHz/Pa |
Plug | 3.5 mm audio jack |
Maximum operation temperature | 45°C |
Cable length | 100cm/39.35 inches |
Dimension Specifications
Dynamic driver | 32mm/1.25" |
---|---|
Weight | 105g/0.231 lbs |
Documents & Downloads
Spec Sheets
Gallery






What’s in the Box
- 1 pair of Jr310 headphones
- Warranty card
- Warning card

FAQs & How-Tos
-
Audio Cable Information
This headphone does not feature an audio cable jack. This is a Bluetooth only headphone.
Was this helpful? Thank you for your feedback!
-
Headphone Material Information
These headphones consist of plastics, synthetic leathers and foams. All JBL Jr products were put through extensive tests and are compliant with Standard Consumer Safety Specification for Toy Safety.
Was this helpful? Thank you for your feedback!
-
Reset Information
To reset the headphones, power on the headphones and plug in the USB cable into a USB charger or USB port. Paired mobile devices should disconnect and the led should be constant white. When unplugging the USB cable, the headphones will power off. When manually powering on the headphones, and the last connected mobile phone is not in range, the headphones will revert to Bluetooth Pairing mode ( blue led will blink ) after 5 seconds. Was this helpful? Thank you for your feedback!
-
Microphone Information
Yes. This headphone has a built in microphone. To answer a call, press the power button which is located on the Left Ear Cup for 1 second. If you wish to hang up the call, press and hold the power button for 2 seconds.
Was this helpful? Thank you for your feedback!
-
Power and Pair Information
Press and hold the power button located on the RIGHT ear cup. Make sure that the device is on and in Bluetooth range. If this is the first time connecting the device, it will automatically go into pairing mode. You will notice the LED light alternate between blue and white as it searches for a device to connect to. The headphones should pop up on your list of discoverable devices within 3-5 seconds, and connect.
Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Call Us
Talk to a product expert
Call us now at:
(800) 336-4525
Mon - Fri: 9:00 am - 11:00 pm (EST)
Sat - Sun: 9:00 am - 5:00 pm (EST)
Chat With Us
Mon - Fri - 9:00 a.m 11:00 p.m (E.T)
Sat - Sun - 9:00 a.m 5:00 p.m (E.T)