As with all in-ear headphones, our range of TWS headphones can be susceptible to a build up of dust and earwax. This can cause low volume on one or both earbuds, or balance issues (e.g. right earbud is louder than the left earbud). To reduce the likelihood of these issues occurring, it is a good idea to periodically clean your earbuds and your ears. Clean the earbuds by removing dust and wax after each use, using a pointed toothpick to remove larger amounts and a small amount of rubbing alcohol applied to a cotton swab for final degreasing.

If you are experiencing volume or balance issues, always check for wax and dirt in and around the earbud and driver and complete cleaning of the earbuds as described above. If the issue persists, there may be earwax/dirt stuck in the small holes in the grille in front of the driver, preventing sound output. To resolve the issue try dipping the affected earbud tip into a solution of lukewarm tap water and a small amount of dish soap (washing up liquid). The earbud tip should only be put into the liquid up to a maximum depth of 1-2 mm only (see images below). Immersing the earbuds in water or putting the earbuds in water at a larger depth than this could void your warranty. Keep the earbud tip in the water for about 2-3 minutes, then wipe/clean the grille with a small brush (such as a toothbrush). The should remove the wax and resolve the volume/balance issues.

 

There is no plan for adding JBL Connect support for Playlist speaker. But you can group any speaker together that support Chromecast built-in for multi-room experience.

Yes, if no audio is present and no buttons are pressed, DUET will go into standby after approx. 10 minutes.

This speaker will go to standby mode after 10 minutes inactivity. It turn on when you start playing to it again.

Using Wi-Fi allows you to listen to your music in a higher sound quality since Bluetooth protocol compresses the audio signal, where Wi-Fi data easily stream HD Audio content. Take calls without interrupting your current audio music, where Bluetooth will interrupt the stream, because it is a one-way protocol. Control your music from anywhere in the house, where Bluetooth have a limited range. Play the same music across multiple speakers and when using the newest connect features, such as Spotify Connect or Chromecast built-in, then you don't have to worry about battery life, since the devices playing is doing all the data transmission compared to Bluetooth, where it is data between source and device.

We believe the baseline performance of the QuantumSPHERE technology is cutting edge in terms of localization. The calibration feature improves upon this performance by calibrating the system to your individual anatomy.

Make sure the headset volume control is turned up and your microphone is unmuted. Check that only one voice chat application is in use while in-game. If you're connected to the PC, make sure that the communication device is selected under Control Panel > Sound > Recording. Select the JBL product and select "Set as Default Device". Check on the top bar of the JBL QuantumENGINE whether your headset's game-chat balance dial is set correctly.

Make sure the volume control on the headset is turned up. Rotate the volume wheel on your headset to increase the volume. If you're connected to the PC via USB, check that the default communication device is selected under Control Panel > Sound > Playback. Select JBL Quantum ONE Chat, right-click, and select "Set as Default Commuication Device". Check your headset's game audio chat balance dial, and ensure that the balance is correct. Check the JBL Quantum ONE Chat device and make sure it is not muted or turned all the way down.

Make sure the volume is turned up and that the correct device has been selected in the system sound settings. Check the computer volume levels and make sure it is not muted or turned all the way down.

Make sure the headset volume control is turned up. Rotate the volume wheel on your headset to increase the volume. If you're connected to the PC via USB, check that the default device is selected under Control Panel > Sound > Playback. Select JBL Quantum 400 Game, right-click, and select "Set as Default Device".  Check on the top bar of the JBL QuantumENGINE whether your headset's game-chat balance dial is set correctly. Check the JBL Quantum 400 Game device and make sure it is not muted or turned all the way down.

The “Speaker” mode allows the JBL QuantumENGINE to receive more than two channels of audio. It also prevents some applications from adding extra signal processing intended for other headphones, which would negatively impact the performance of the JBL QuantumSURROUND or JBL QuantumSPHERE 360 technology.

JBL Quantum 300, 350, 400, 600, 610, 800, 810 ONE, TWS and Stream are working with the QuantumENGINE

JBL Xtreme, JBL Pulse 2, JBL Charge3, JBL Flip 3, Pulse 3, and Flip 4 Android, Google Now, Google Play are trademarks of Google Inc. Siri, iTunes, and Apple Music are trademarks of Apple Inc. Spotify is a registered trademark of Spotify AB. IOS is a registered trademark of Cisco in the US and is used by Apple under license.

Connecting a USB stick

1. You can enjoy music from your USB Stick directly into the Partybox device.
2. Insert the Stick into theport, located on the back of your Partybox.
3. The USB Stick has to be formatted FAT16 or FAT 32 and supports MP3, WAVE and WMA Music files.
4. It will start automatically playing the content on your USB stick.

AUX Connection

1. You can connect any devices through the analog connection
2. Use an analog cable (Not included in the box) and connect your device.
3. Press play on your external device and enjoy the music!

RCA Connection (*Partybox 200/300/1000 Only)

1. The Partybox features both Input and Output RCA connection.
2. Connect your RCA cable (not included) to either one of the ports.
3. You can use it with your DVD/BlueRay player or AVR system.

Guitar and Microphone

1. Connect your to the dedicated port or connect your electric   to the
2. You can mix sound or make your own karaoke party with your Partybox.
3. Sing or play through your devices.
   1. To adjust the volume of the audio source, press volume+ or volume- buttons.
   2. To adjust the volume of the microphone or guitar, rotate the or

 

Charging external devices

1. Whenever your mobile device needs some extra power, the Partybox can help you!
2. Featuring a USB Charging port for both Music (USB on a stick) or when you need to charge your device.
3. Simply connect your device to the port and start charging.
   1. NOTE: The Partybox 200 needs to be connected to AC power all the time to charge or function as a speaker.
   2. The Party 300/310 has a battery and can charge any device without needing AC power (unless the product's battery is depleted then you need to recharge via AC power).

There are many ways to enjoy your JBL Partybox On-The-Go, 100, 200, 300, 310 & 1000. The options are endless and you are in control of the party

It is a tiny white sticker, located on the inside of the left-hand size adjustment slider on E35.

The heart rate sensor is located inside the RIGHT earbud inside the sound tunnel. If the Heart Rate detection is activated and you remove the RIGHT earbud, the audio voice will notify you to insert the ear bud and will recalibrate once it is detected again.

At the bottom of your Horizon alarm clock, you will see a little cap where the backup-battery resides. Turn the cover lid left to open it, and on the back of the cover lid, you will see the serial number.

NOTE:  LINK speakers must be set up on a WiFi network before Bluetooth can be activated. Once it is set up, you can use Bluetooth anywhere (Unless you reset the speaker and start all over with installation).

Pairing issues with a Smartphone or Tablet:

1. First try to restart the Bluetooth connection on your source device (Smartphone/tablet) by switching Bluetooth off and on again with a short pause in between.
2. Forget previous paired connection (on your smartphone/tablet) in your Bluetooth settings if you once had paired with our product.
3. Try to restart source device(Smartphone/tablet) by powering it off and on again, and after restart try to establish a Bluetooth connection to your JBL LINK device.
4. If above does not work, then try to restart your JBL LINK device by turning it off and on again.
5. Press and hold down the Bluetooth button on your JBL LINK device to initiate pairing mode again.
6. Go into Bluetooth settings on your Smartphone/tablet.
7. Perform a restart or reset if you are not able to connect after above steps.

Back to helpful articles --> Articles overview

JBL LINK Bluetooth specifications:

• Bluetooth version 4.2
• A2DP v1.3 with SBC Audio Codec.
• AVRCP v1.5

You can manually type in the network name (SSID) and password to connect if the network does not appear.

What you are experiencing is normal. The Inspire 700 is actually the Inspire 500 headphone but with the added bonus of a charging case.

What you are experiencing is normal. The Focus 700 is actually the Focus 500 headphone but with the added bonus of a charging case.

Some head units in the vehicles use isolated grand, if JBL DRG use isolated grand as well, this will disable the chips inside DRG. Please connect your smartphone with JBL DRG and disable the “Aux Noise Cancel” button in the Apps right after Aux Line option in Connection Mode section.

Some vehicles don’t provide an isolated ground for the head unit which may introduce noise. Please connect your smartphone to JBL DRG and enable the “Aux Noise Cancel” button in the App. This can be found right after Aux Line option in Connection Mode section.

The wireless charge receiver in the smartphone may not be adequately coupled to the wireless charging transmitter on Smartbase. Re-adjust your smart phone’s position on the wireless charge arm.

The PartyBoost feature is not available when your JBL speaker is connected to a computer via Bluetooth. This is a technical limitation. When connected to a computer, the computer is acting as the primary device. Therefore, the JBL speaker does not have control of re-transmitting the Bluetooth signal to other JBL speakers.

NOTE: Speakers effected by this are the JBL Flip 5, JBL Flip 6, JBL Charge 5, JBL Pulse 4, JBL Xtreme 3, and JBL Boombox 2, as well as all future products featuring the PartyBoost feature.

• Please check whether your head unit Bluetooth support EDR (Enhanced Data Rate) • If the head unit does not support EDR this will cause the transfer data rate to be low and will impact the audio quality.

JBL QuantumSPHERE 360 is JBL QuantumSURROUND that’s kicked up a notch by using a head-tracking sensor to fix sounds in 360 degrees of space around you. With typical headphones, when you move your head, the soundscape follows your movement. But with JBL QuantumSPHERE 360, if you rotate your head, the sound source’s perceived location stays in place because the head-tracking sensor compensates for your head movement. For example, if there’s a sound coming from in front of you, and you turn your head to the left, the sound source’s perceived location moves to your right ear—the sound stays locked in space as you move your head. 

Also, the human brain uses small head movements to distinguish if sound sources are behind or in front of us. The brain processes the differences between when a sound arrives at the left vs. the right ear to determine where the sound is located. So with JBL QuantumSPHERE 360, you can move your head naturally to pinpoint the exact source of sounds around you. 

Getting started with the checklist

• A JBL LINK device(s).
• Latest version of the Google Home app installed on your mobile device.
• Latest version of the Google app  (Android only) installed on your mobile device.
• A Google Account (you can create one online via Google).
• A mobile device with either iOS or Android support.
  • ​Must have iOS 10 or higher
  • Must have Android 5.0 and higher
  • There is no support for PC set up.
• An internet connection from your local ISP (Internet Service Provider).
• Your Wireless Network must secured with WPA2 Encryption (Enterprise mode NOT supported). 
• Availability and performance of certain features, services and applications are device- and network-dependent and may not be available in all areas; subscription(s) may be required, and additional terms, conditions and/or charges may apply.

Wi-Fi requirement

• Wi-Fi routers must have Encryption enabled to install JBL LINK speakers (WPA2 etc).
• Wi-Fi Extenders need to feature support of Multicast forwarding and UPnP.
• Always use 5 GHz Wi-Fi for best performance and less interference.
• For routers that have 2.4G Wi-Fi support only, make sure that they are using channels 1, 6 or 11 only.

You can now install your JBL LINK speaker to your Wireless Network and you can find our setup article that shows how to install your LINK product.

 

The JBL Quantum ONE headset is compatible via 3.5mm jack with PC, PlayStation, Xbox, Nintendo Switch, Mobile, Mac and VR. You can use the USB connection with PC.

Windows Sonic is a virtual surround algorithm that is built into Windows 10 PCs. You can read more here:
https://docs.microsoft.com/en-us/windows/win32/coreaudio/spatial-sound