JBL Vibe 300TWS

JBL Vibe 300TWS

Ekte trådløse ørepropper

Sold from 2022 until now

Getting started with your JBL Vibe 300TWS

Getting started with your JBL Vibe 300TWS

Quick Start Guide

Get up and running in no time with our easy-to-follow Quick Start Guide

Product Registration

Register your product

Do you own this product? Register it here! And claim your warranty or service easily

Register now

Documents & Downloads

Product Specifications

Driver size (mm)
12
Driver sensitivity at 1kHz/1mW (dB)
105
Dynamic frequency response range (Hz)
20 Hz – 20 kHz
Impedance (ohms)
32
Number of drivers per ear
1
Weight (g)
7.7
Weight (oz)
.27
Bluetooth version
5.2
Bluetooth profiles
A2DP V1.3 AVRCP V1.6 HFP V1.7
Bluetooth frequency
2.4 GHz - 2.4835 GHz
Bluetooth transmitted modulation
GFSK, π/4–DQPSK, 8–DPSK
Charging time (hours from empty)
2
Maksimum spilletid (timer)
6
IP Code
IPX2
Charging cable
Ja
Voice Assistant integration
Ja
Built-in Microphone
Ja
Hands Free Call
Ja
Sweat Proof
Ja
Touch Control
Ja
True Wireless
Ja
Wireless
Ja
Charging case
Ja
Speed charge
Ja
Rechargable battery
Ja
Bluetooth
Ja

Ekte trådløse ørepropper

Hold deg på toppen. JBL Vibe 300TWS-ørepropper gir deg musikk mens du holder kontakten med omgivelsene dine uten ledninger som holder deg tilbake. Nyt 26 timer med kraftig lyd beriket med JBL Deep Bass. Hold kontakten på farten med stereosamtaler uten irriterende bakgrunnsstøy. Administrer lyd og håndfrie samtaler fra én av øreproppene eller begge, takket være praktiske berøringskontroller. Ergonomisk designet, passer «stick-designet» tett og diskré i ørene dine for å holde deg komfortabel og tilkoblet hele dagen, slik at du aldri går glipp av en tone – eller en samtale.

En kraftig 12 mm driver leverer JBL Deep Bass-lyd slik at du ikke bare hører musikken, du føler den.
Gå aldri glipp av en rytme med 26 timers kombinert spilletid (og 6 timer i ørepluggene). Eller, når du trenger en rask oppladning, kan du hurtiglade enda en times spilletid på bare 15 minutter og full lading på 2 timer.
Vibe 300TWS-øreproppene med enkel mikrofon eliminerer bakgrunnsstøy slik at du kan nyte samtaler med stereokvalitet mens du er på farten. Styr lyd og ta anrop enkelt og håndfritt, direkte fra øreproppene!
Du kan enkelt skifte mellom mono og stereo når som helst i venstre, høyre eller begge øreproppene mens du ringer, nyter musikk eller snakker med stemmeassistenten din.
Den praktiske, regnbestandige IPX2-certified designen til JBL Vibe 300 TWS-ørepropper betyr at du kan nyte musikken din når som helst – enten det regner eller er solskinn.
Bekvemmelighet for hånden. Aktiver alle lydfunksjonene til JBL Vibe 300TWS enkelt med berøringskontroll og få tilgang til enhetens taleassistent direkte fra øreproppene.

FAQs & How-Tos

3 results
  • As with all in-ear headphones, our range of True Wireless Stereo headphones can be susceptible to a build up of dust and earwax. This can cause low volume on one or both earbuds, or balance issues (e.g. right earbud is louder than the left earbud). To reduce the likelihood of these issues occurring, it is a good idea to periodically clean your earbuds. Clean the earbuds by removing dust and wax after each use, using a pointed toothpick to remove larger amounts and a small amount of rubbing alcohol applied to a cotton swab for final degreasing. Remember to clean the charging points on the headphones and inside the charging case.

    If you are experiencing volume or balance issues, always check for wax and dirt in and around the earbud and driver and complete cleaning of the earbuds as described above. If the issue persists, there may be earwax/dirt stuck in the small holes in the grille in front of the driver, preventing sound output. To resolve the issue try dipping the affected earbud tip into a solution of lukewarm tap water and a small amount of dish soap (washing up liquid). The earbud tip should only be put into the liquid up to a maximum depth of 1-2 mm only (see images below). Immersing the earbuds in water or putting the earbuds in water at a larger depth than this could void your warranty. Keep the earbud tip in the water for about 2-3 minutes, then wipe/clean the grille with a small brush (such as a toothbrush). This should remove the wax and resolve the volume/balance issues.

    cleaning-earstick-tip 
  • Double-tap the button on the right earbud, then on the third tap - press and hold the button for more than 5 seconds (until the unit shuts off). 
    This restores the earbuds to the factory defaults.
    TWS must be connected to perform the reset, so neither of the earbuds should be off or in the charging case.
    It also may be necessary to remove or forget the earbuds from the list of paired Bluetooth devices in order to pair again.
  • If you are having trouble pairing your headphones or if your device is asking for a PIN, please make sure to check all available BT connections in your device's settings. Verify that you are connecting to the headphone's product name that excludes 'LE'. The 'LE' connection is only intended for voice assistant feature compatible with your headphones. If the voice assistant feature has not yet been configured, this would explain why the 'LE' connection appears as an available connection, but cannot be used for Bluetooth audio.

    https://harman.widen.net/s/dtsldx6jxx/bluetooth-pairing-issue-with-voice-assistant-headphone-le-image1 

Can’t find what you’re looking for?

Call us

Call us

Call us now at: +47 21 93 29 30

Monday - Friday: 09.00-17.00

E-mail us

E-mail us

We are here Monday – Sunday to answer you as fast as we can!

Email us
Chat with us

Chat with us

Monday - Friday: 09.00-18.00
Saturday - Sunday: 10:00-16:00

message

WhatsApp Us

Send us a message here 

Monday - Friday: 09.00-18.00
Saturday - Sunday: 10:00-16:00