Support Overview / Car & Marine / Car Electronics / Amplifiers / Amplifiers (stereo) / GXA602

GXA602

2 channel amp (2x60W)

Sold from 2013 until 2014

Getting started with your GXA602

Documents & Downloads

Manuals

Brukerveiledning (Engelsk) 1.78 MB

Product Specifications

Generelle Spesifikasjoner

Number of Channels: 2 channels

Total Peak Power Output: 280W

Frequency Response: 20Hz−20kHz ±1dB

MSRP U.S.: $119.95 each

Spesifikasjoner lyd

Input Sensitivity: 200mV-20V

4-Ohm Power Output: 60 Watts RMS x 2 channels

Signal-to-Noise Ratio: 93dB

2-Ohm Power Output: 85 Watts RMS x 2 channels

Variable Bass Boost: + 12dB @45Hz

Bridged Power Output: 170W x 1 into 4 ohms

Frequency Response: 20Hz-20kHz

Total Peak Power Output: 280W

THD + N: <1%

Dimensjoner

Depth (in): 7-13/16

Height (mm): 52

Depth (mm): 198

Width (mm): 206

Width (in): 8-1/8

Height (in): 2-1/16

The GX-A602 brings studio-quality audio to your car. With total peak power of 280 watts packaged inside a tiny footprint of just 2-1/16 inch (52mm) high, 8-1/8 inch (206mm) wide and 7 13/16 inch (198mm) deep, the GX-A602 is compact but mighty. Supports 2-channel full range, high pass operation or bridged mono for a subwoofer. Features include a cast-aluminum heat sink, built-in electronic crossover networks and a switchable bass boost.

FAQs & How-Tos

1 results

Sort

Page size

In the owner's manual, the trigger input is described as "optional". But without a trigger cable, it seems impossible to switch the amplifier on and off. How come?

The amplifier has a signal sensor on the high-level (speaker level) inputs, so it is not necessary to use a trigger cable when input is high-level, and connected to the high-level inputs. However, low-level input signals through the RCA-phone input sockets do not activate a signal sensor, so use of a trigger cable is MANDATORY for low-level input signal use.

Was this helpful? Thank you for your feedback!