JBL Everest Elite 700
Around-ear Wireless NXTGen Active Noise Cancelling Headphones
Sold from 2015 until now
Documents & Downloads
Product Specifications
- Driver size
- 40mm
- Dynamic frequency response range
- 10-22kHz
- Driver sensitivity
- 102dB/1kHz, 1mW
- Maximum SPL
- 117dB
- Rated power input
- 30mW
- Microphone sensitivity
- -42dBV/Pa
- Weight (g)
- 274
- Dimension W x H x L (mm)
- 76.9 x 176.5 x 169.5
- Bluetooth transmitted power
- <4dBm
- Bluetooth transmitted modulation
- GFSK π /4, DQPSK, 8-DPSK
- Bluetooth spec
- 4.1
- Bluetooth profiles
- A2DP V1.3, AVRCP V1.5, HFP V1.6, HSP V1.2
- Battery type
- Polymer Li-ion Battery (3.7V, 850mAh)
- Music play time with BT on
- up to 25 hours
- Driver sensitivity
- 99dB@1kHz, 1mW
- Driver size (mm)
- 40
Experience a New Standard in Wireless Headphones
JBL EVEREST™ ELITE 700 is legendary sound brought to a new standard. Bluetooth 4.0 enables wireless connectivity while new NXTGen Active Noise Cancelling Technology combines the immersive experience of noise-cancelling with the ability to control the amount of outside noise to let in, giving you the power to balance awareness of your surroundings with your listening experience. With legendary JBL Pro Audio sound delivering a dynamic acoustic experience, sculpted ear cushions providing unprecedented fit on your ears, a 15-hour rechargeable battery, and TruNote™ Auto Sound Calibration, now you can enjoy ultimate comfort, freedom and personalization. A built-in microphone allows for easy call access.
FAQs & How-Tos
-
It is possible to replace the ear pads, but there are details to consider. On Elite 700: The ear pads are held in place by a plastic plate with claws, and some of the claws will most likely break off when you remove the pad. You do this by grabbing under the edge where the fabric ends, then pulling hard outward. The claws will eventually let go, and some of them will break off, rattling inside the ear pod. The only way to get them out is to unscrew the speaker plate, lift it up, and shake out the broken-off claws. The new pads are simply centered over the speaker plate, and the claws pressed into the holes with a firm pressure. On Everest 700: The ear pads are glued into position with double-adhesive tape. Pull the old pads off with a forceful, steady pull, until the glue lets go. Remove the protective layer on the new pads, and carefully position them correctly before pressing home all the way around the edge.Was this helpful? Thank you for your feedback!
-
No. The only way that the Noise Cancellation feature can be activated is while you are using the headphones wirelessly. You cannot use NC while the headphones are plugged into a device or charging.Was this helpful? Thank you for your feedback!
-
No, the app works with the ELITE models only. These are the ones that feature Active Noise Cancelling.Was this helpful? Thank you for your feedback!
Images & Videos
Can’t find what you’re looking for?
Call Us
Talk to a product expert
Call us now at:
+959-97-400-5050
TMW Address : No. (7/B), Maharsi Sarsana Yakethar street, Bahan Tsp, Yangon, Myanmar
Mon - Sat - 8:00 a.m 5:00 p.m
