POWER P562を始める
ドキュメントとダウンロード
製品仕様
- Series
- Power Series
- Type
- Two-Way
- Size
- 5-1/4
- MSRP U.S.
- $169.95 per pair
- Sensitivity
- (2.83V@1m) 92dB
- Power Handling (RMS)
- 55W
- Nominal Impedance
- 2 ohms
- Power Handling (Peak)
- 165W
- Frequency Response
- 55Hz – 23kHz
- Mounting Depth (in)
- 2-1/16
- External Diameter Woofer (in)
- 5-1/8
- External Diameter Woofer (mm)
- 130
- External Diameter (in)
- 5-1/8
- External Diameter (mm)
- 130
- Mounting Depth (mm)
- 52.5
- Mounting Cutout Diameter (mm)
- 120
- External Diameter Tweeter (mm)
- 51.6
- Mounting Cutout Diameter (in)
- 4-3/4
- External Diameter Tweeter (in)
- 2-1/16
5-1/4 inch 2-Way Loudspeaker with Plus One HCL woofer cone and high-bandwidth edge-driven textile dome tweeter
The Plus One® Honeycomb-Laminate™ woofer cone is exceptionally stiff and lightweight, with up to 25 percent more active surface area than a standard one of the same size. With a long-excursion surround, it boosts bass output and efficiency by 2 to 3 decibels compared with others.
It’s not the miniatures that most others use, but a high-bandwidth, edge-driven textile-dome tweeter like those found in very high-end home audio loudspeakers. Crank it up. You get less distortion even at high volumes and superior integration with the woofer.
Another JBL feat of engineering: the P562 features a tweeter mounted on a 15-degree angle. You can rotate it nearly 360 degrees to aim it at the listening position for improved high-frequency response.
The JBL® P562 has tweeter-level control. Use the simple switch to set the tweeter output level to match your personal listening preference or different mounting locations.
You’ll have 55 watts RMS and 165 watts peak power handing and 92dB sensitivity. And push them to the limit. You’ll hear true JBL® sound, nothing is under- or over-emphasized. The P562 has a frequency response of 55Hz to 23kHz.
In addition to better sound quality, the new, proprietary, JBL-patented woofer design offers far higher SPL (sound pressure level) and better suspension symmetry for lower distortion than the previous generation.
These speakers make the best use of any amplifier by providing an optimum 2-ohm load. They use a lower-impedance voice coil than a typical speaker to extract the most power and performance possible from all amplifiers engineered to drive loads of 4 ohms or less.
Outboard crossovers are integrated into a harness connected to each speaker for easy installation. Oversized Direct-Connect terminals ensure perfect connectivity for bare speaker wires.
画像＆ビデオ
なにかお困りですか？
こちらはコンシューマー向けJBL製品に関するお問い合わせ専用窓口となっておりますので、車載オーディオ機器については車両販売店様または車両メーカー様へ、プロフェッショナル機器についてはプロフェッショナル機器の販売店様・代理店様へのお問い合わせをお願いいたします。
チャットでのお問い合わせ
受付時間: 土日・祝日・年末年始を除く、平日9:30～17:30