How To
How To
909 results
-
We only offer volume+ and volume-, mute and power for your TV remote to learn these IR codes.Was this helpful? Thank you for your feedback!
-
Yes, you can listen to music via cabled connection while you charge the battery. As soon as you insert the charging cable, all active circuits are switched off, and only the analog cable input remains active. When charging has finished, you can use the wireless and noise cancelling functions again.Was this helpful? Thank you for your feedback!
-
Yes, but only via cabled connection. When you insert the USB charging cable, Bluetooth is switched off, so wireless listening is not possible.Was this helpful? Thank you for your feedback!
-
Yes, but only via cabled connection. When you insert the USB charging cable, Bluetooth is switched off, so wireless listening is not possible.Was this helpful? Thank you for your feedback!
-
Yes, but only via cabled connection. When you insert the USB charging cable, Bluetooth is switched off, so wireless listening is not possible.Was this helpful? Thank you for your feedback!
-
Unfortunately, you cannot turn on and use the headphones while they are charging.Was this helpful? Thank you for your feedback!
-
Yes, these headphones can be connected and paired to two devices at the same time.Was this helpful? Thank you for your feedback!
-
Yes, you can use them for telephone conversations in both Bluetooth and wired mode when paired with a smart device.Was this helpful? Thank you for your feedback!
-
The JBL Quantum Stream Studio comes with an adapter that can be mounted on different boom mic arm systems or tripods. The adapter is already built in the microphone stand so that you always have the adapter close to you when needed.
Was this helpful? Thank you for your feedback! -
Yes. Out-the-box the JBL Bar series soundbar recognizes volume and mute controls from the most common TV remote controls. The JBL Bar series has IR learning. You can use this feature to teach the soundbar to response to your TV's remote control as well.Was this helpful? Thank you for your feedback!
-
Yes, use the MONITOR OUT sockets (1/4” and RCA are available on 208P, RCA on ONE) to feed into a recording device. Please note that these outputs are volume controlled, so set the volume correctly, depending on the sensitivity of the recording device.Was this helpful? Thank you for your feedback!
-
It is possible to replace the ear pads, but there are details to consider. On Elite 700: The ear pads are held in place by a plastic plate with claws, and some of the claws will most likely break off when you remove the pad. You do this by grabbing under the edge where the fabric ends, then pulling hard outward. The claws will eventually let go, and some of them will break off, rattling inside the ear pod. The only way to get them out is to unscrew the speaker plate, lift it up, and shake out the broken-off claws. The new pads are simply centered over the speaker plate, and the claws pressed into the holes with a firm pressure. On Everest 700: The ear pads are glued into position with double-adhesive tape. Pull the old pads off with a forceful, steady pull, until the glue lets go. Remove the protective layer on the new pads, and carefully position them correctly before pressing home all the way around the edge.Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Call Us
To speak to our customer service specialist
1800-102-0525
Mon - Sun: 10:00 am - 7:00 pm (IST)
