How To
How To
904 results
-
100 is in-ear, 300 is on-ear, 700 is over-ear.Was this helpful? Thank you for your feedback!
-
You'll have all the benefits from HDMI 2.0, but with 2.0a you will also have HDR (High Dynamic Range). Don't confuse HDR with cameras, this is used for TV's that support HDR content. In short, if a Blu-Ray supports HDR, it can enhanced dark scenes from a movie with this option.Was this helpful? Thank you for your feedback!
-
The difference is that the new ECO versions of Go 3 and Clip 4 are made from 90% PCR (Post-Consumer Recycled) plastic and wrapped in 100% recycled fabric on the speaker grille, while still delivering the same rich JBL Original Pro Sound and significantly reducing the carbon footprint of the product.
Was this helpful? Thank you for your feedback! -
The difference is the BTA unit, which is a Bluetooth transmitter. The Soundgear BTA comes with the BTA unit in the box. The Soundgear does not. The BTA can be connected (with a signal cable) to a TV set, a CD player, or any other stereo line-level source, and can then stream this signal to the Soundgear wirelessly, via Bluetooth. TV sound or game sound are possible, since the BTA and the Soundgear use aptX Low Latency, which reduces the audio delay to levels, where picture and sound will be closely synchronized. This is also the secret behind the option to connect two Soundgears to one BTA unit, for two people to share a TV transmission, or a video game. Actually, you can use the BTA to stream to most other Bluetooth headphones and loudspeakers, but only if these devices also support aptX LL will the delay be low enough for video use.Was this helpful? Thank you for your feedback!
-
The physical battery in Boombox has a capacity of 10.000mAh @7.4V. This is the charged battery storage. When outputting ( so power from the battery is drawn ), it's using 3.7V, half the storage voltage, which will give you 74Wh - equivalent to a 20.000mAh battery with power stored at 3.7V.Was this helpful? Thank you for your feedback!
-
Since there is no fixed standard for headphone connections, there are two cables in the box, with different polarity. If one cable does not give good audio results, try the other cable. This usually solves the problem. The majority of phone models (Apple, Samsung from Galaxy S2 model, LG, HTC, Sony, Motorola, Blackberry) require the audio cable with the silver plugs. Pin assignment in this cable from the tip of the plug: R/L/Ground/Microphone. However, some manufacturers, such as some models from Nokia, require a cable with different pin assignment, (R/L/Microphone/Ground). In this case, you should use the audio cable with the black plugs.Was this helpful? Thank you for your feedback!
-
The Endurance Jump features the power hook which provides a secure fit ear hook design, which automatically turns the power on/off when putting on or taking off the earphones. The Sprint does not feature the power hook and you manually have to turn on/off the headphones by pressing and holding the JBL logo on the RIGHT ear hook.Was this helpful? Thank you for your feedback!
-
Wireless: Old name is Headphone Wireless. New name is Sport Wireless. Body is re-designed, the new body is smaller in diameter, but a bit longer. Angle of sound tube is changed slightly. Audio performance is improved. Enhancers slightly changed. Heartrate: Old name is Headphone Wireless Heartrate. New name is Sport Wireless Heartrate. Construction and design are unchanged.Was this helpful? Thank you for your feedback!
-
The only difference between the 500 and 700 series is that the 700 model provides you with a charging case. The features and functionality on the actual headphones themselves are the same.Was this helpful? Thank you for your feedback!
-
The only difference between the 500 and 700 series is that the 700 model provides you with a charging case. The features and functionality on the actual headphones themselves are the same.Was this helpful? Thank you for your feedback!
-
The distance between wall-mounts centers are: JBL BAR Studio: 45 cm. JBL BAR 2.1: 70 cm. JBL BAR 3.1: 70 cm. JBL BAR 5.1: 61 cm JBL BAR 5.1 Surround: 71.85 cm JBL BAR 9.1: 55,5 cmWas this helpful? Thank you for your feedback!
-
Software version v.7.9 is the latest for the Flip 3Was this helpful? Thank you for your feedback!
-
JBL Bar 9.1 is 884 mm (without the surrounds in charging position). Surrounds add approx. 160 mm on each side, in charging position.Was this helpful? Thank you for your feedback!
-
With the speaker ON, press and hold the VOL+ and Pause/Play buttons for 5-6 seconds. The Xtreme shuts down, and is now reset. You will need to 'forget' the speaker in Bluetooth settings on your phone/tablet in order to pair it again.Was this helpful? Thank you for your feedback!
-
Speakers will dual tweeters gives listeners the ability to have a single speaker to drive two independent channels, ideally stereo left and right. Dual tweeter speakers are usually used for in-ceiling audio applications. They have four terminals (two sets of positives and negatives) used to plug in speaker wires from the amplifier.Was this helpful? Thank you for your feedback!
-
The range is approximately 10 meters, depending on the environment.Was this helpful? Thank you for your feedback!
-
These are the supported languages for the Everest GA series.
- English (US, UK, CA, IN, AU)
- German
- French (CA, FR)
- Japanese
- Portuguese (BR)
Was this helpful? Thank you for your feedback! -
This connection is intended for software and service updates only.Was this helpful? Thank you for your feedback!
-
Voltage is 100 - 240 Volt AC. Maximum power consumption is 120 Watts.Was this helpful? Thank you for your feedback!
-
Soundgear Sense provides two wearing styles, either as regular TWS headphones with an ear hook for a secure fit, or as a neckband headphone with the optional detachable neckband. Both wearing styles offer the same open ear experience with rich, full-range sound, it is just a matter of your own preference or use case which wearing style you choose.
Was this helpful? Thank you for your feedback! -
Now, with Google Assistant and Alexa available simultaneously on your JBL Authentics speakers, you can choose to use one or both voice services available. This means you can set up just Alexa, just Google Assistant, or both. If you choose to set up both services, they will be at the ready. You can use either of them whenever you want simply by saying either “Hey Google” or “Alexa”.
Was this helpful? Thank you for your feedback! -
Windows Sonic is a virtual surround algorithm that is built into Windows 10 PCs. You can read more here:
https://docs.microsoft.com/en-us/windows/win32/coreaudio/spatial-soundWas this helpful? Thank you for your feedback! -
The JBL Quantum Stream microphone is compatible with the JBL QuantumENGINE software. You can customize or use the following settings/features via the JBL QuantumENGINE:
Microphone settings
Polar patters (Cardioid / Onnidirectional)
Equalizer
RGB LED Light colors + animations/effects
Update firmware + softwareWas this helpful? Thank you for your feedback! -
Only data to make Google Assistant more efficient and Google services faster. When interacting with the speaker you will receive more personalized feedback in the future.Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Call Us
To speak to our customer service specialist
1800-102-0525
Mon - Sun: 10:00 am - 7:00 pm (IST)
WhatsApp Us
Chat with a support agent via Whatsapp at:
by clicking https://bit.ly/2SfFSPh or send hi to 91 70658 44446
Mon - Sun: 10:00 am - 7:00 pm (IST)