


JBL Endurance JUMP
Product Specifications
General Specifications
Driver size (mm) | 10.0 |
---|
Audio Specifications
Number of drivers per ear | 1.0 |
---|---|
Driver sensitivity at 1kHz/1mW (dB) | -20dB |
Dynamic frequency response range (Hz) | 20Hz–20kHz |
Impedance (ohms) | 16.0 |
Control Connect Specifications
Bluetooth version | 4.2 |
---|---|
Bluetooth profiles | HFP v1.6, A2DP v1.3, AVRCP v1.5 |
Bluetooth frequency | 2.402GHz-2.48GHz |
Bluetooth transmitted modulation | GFSK, π/4DQPSK,8DPSK |
Bluetooth transmitter power | 4 dbm |
Documents & Downloads
Spec Sheets
Quick Start Guide
Gallery







Videos
What’s in the Box
- 1 x Headphones
- 1 x Charging cable
- 3 x Sizes of ear tips
- 1 x Enhancer
- 1 x Sport Carry Pouch
- 1 x Safety Sheet / Quick start guide
- 1 x Warranty / Warning

FAQs & How-Tos
This unit is IPX7 rated, which means that you can submerge the unit in water as deep as 3 feet (1 meter) for up to 30 minutes.

For all models except Endurance Peak:
Press the headphone touch control located on the RIGHT ear loop for 15 seconds while the headphones are being charged.
Note that resetting the Dive will not erase music contained in the MP3 memory.
Endurance Peak reset: While the pods are being charged, tap the touch pad on the right pod once, then tap again and hold for approx 18 seconds, or until the LED blinks.
Can’t find what you’re looking for?
Call Us
To speak to our customer service specialist
1800-102-0525
Mon - Sun: 10:00 am - 7:00 pm (IST)