JBL Quantum ONE

The Game-Chat balance dial only works when your headset is powered on. Please note that it supports connection with a USB Type A to C cable and a wireless transmitter dongle, but doesn’t support connection through a 3.5mm cable or Bluetooth for mobile games.

Yes. You can configure the volume of the mic monitoring in JBL QuantumENGINE. The default setting of the mic monitoring is "OFF”.

The JBL Quantum ONE provides QuantumSURROUND via the USB connection on PC. You can download QuantumENGINE here: JBLQuantum.com

Yes, you can adjust game and chat audio balance by rotating the puck clockwise and anti clockwise. When rotating the puck, you will feel a notch in the puck that indicates 50 game and 50 chat.

The head tracker in the Quantum ONE uses your movements to calibrate the sensors. You can speed up the calibration process by doing the following: * Imagine that the headphone is a standard cube with 6 faces (Front, Back, Left, Right, Top, Bottom) * Orient the headphone so that it is sitting on each face of "the cube" sequentially. For example, start with the headphone positioned normally (bottom face of the cube down). Then rotate it so that the right side of the cube is facing down. Then continue through the rest of the faces of the cube. * Hold the headphone in each position for 1 second * Once all the faces of the device have been rotated, set the headphone down on a stationary surface for 2 or 3 seconds.

Onboard Adaptive Noise Cancellation is controlled by the multi-function button on the rear of the left ear-cup. Switched on by default, you can SHORT press the multi-function button to toggle from ANC to talk-through. Turn off ANC by long-pressing the multi-function button.  

Ensure that only one voice chat application is in use while in-game. Be sure you hear a click when the microphone is flipped down. The microphone will only function when it is flipped down fully. If you see a red LED on the microphone, it is muted.



How to check your PC settings for the correct recording device
1. Go to Control Panel

2. Select Hardware and Sound

3. Click on Sound

3 Select  Recording


4. Make sure to select the proper recording device.

1. Right-click on it Quantum headset.

   

2. Now select "Set Default Device" or Select "Default Communication Device"

   

5. Check the microphone levels by right-click on your Quantum headset. Then click on Properties


6. Choose Levels.


7. Adjust accordingly.
 

Please also make sure the volume control on the headset is turned up. Rotate the volume wheel on your headset to increase the volume.
Check that your headset's Game-Chat balance dial and ensure that the balance is correct, you might refer to the screenshot below from the QuantumEngine PC software.


If you still cannot hear the game or music audio, or if the volume is still very low, check if the TalkThrough is activated via the QuantumEngine software.


Finally, you can also do a short press on the Smart Ambient button on the headset (if your headset, has this feature)

Onboard Active Noise Cancelling is controlled by the multi-function button on the rear of the left ear-cup. Switched on by default, you can SINGLE press the ANC button to toggle it On/Off  and LONG press to active TalkThru. Turn on ANC again by a single press on the multi-function button.

No, it is compatible with PC and Mac, but not with PS4, XBOX One, Nintendo Switch or Mobile.

You can clean it by wiping it gently with a damp cloth. Take extra care not to let water leak into the speaker chamber, as it will damage the speaker drivers.