Cinema SB350

The most important thing, is to be sure that both blue LEDs must flash quickly, one on the center speaker, one on the subwoofer. If just one of these LEDs does not flash quickly, pairing cannot take place. If it is difficult to make one of the LEDs change to quick flash, it may be that the button is held too long, or not pressed in the right angle. Try again with a short, firm press less then a second.

It is usually not necessary to replace an unresponsive remote control. First, check to see if there is a small plastic tab extending out of the base of the remote control. This is a protective sleeve installed on new remote controls to prevent the battery from draining. Pull this tab to remove the plastic sleeve. The sleeve must be removed before the remote will operate. If the sleeve was removed or not present and the remote control is not working then a new battery should be installed before replacing the remote control. There is a small slide out drawer that houses the battery. The battery type will be either CR2025 or CR2032 for remotes of this size. Replacement batteries are commonly available from most electronic and convenience stores that sell small batteries. Check the number on the original battery and replace it with a battery that uses the same number. These steps will typically solve the problem.

Reset the Soundbar by the same process as when doing "reset remote settings": 1. Switch the SB 350 ON. 2. Press and hold the Surround and Volume (–) buttons simultaneously for about 3-4 seconds, then let go. The Source selection Button flashes amber, followed by the power button and source buttons flashing several times. 3. The soundbar is now reset.

With HARMAN Volume you can set your desired volume between low, medium and high. You can listen to your audio without sudden distracting changes such as blasts from ads, and volume variations as you switch between channels on your TV. Other benefits include full sound effects even at low volumes, this means if you are watching movies (DVD, BlueRay disc) and HARMAN volume is set to low volume, then the signal is more compressed, than what the other volume levels is. This will allow you to hear natural, consistent sound at low volume level, and not only hearing voice conversation from movies, giving you the same movie experience just with lower volume. What is best for you is a matter of personal preference, so we recommend playing around with the three different levels.

The SB 250 has optical and auxiliary connections, while the SB 350 has both connections along with HDMI ARC. The SB 250 has the JBL SoundShift feature (one-button switch between TV and Bluetooth connection), while the SB 350 does not. Compared to the SB 250, the SB 350 has a more powerful subwoofer amplifier. The bigger amp will provide listeners with more bass response.