BAR 1300

Yes!
By using the JBL ONE app, you can change the equalization settings of the speaker to fit your personal taste by adjusting the settings of each frequency to create your personalized EQ:

• BASS: Adjust the lower frequency sounds, such as bass or a kick drum.
• MID: Adjust the mid-frequency sounds, such as human speech.
• TREBLE: Adjust the higher frequency sounds for clarity.

Yes, however, the JBL ONE App gives you another level of control over the speaker/soundbar.
Through the App, you can personalize the speaker/soundbar's performance, such as:

• Customizing EQ settings
• Setting up our new feature called: My Moment 
• Connect your favorite streaming music services.

Once the speaker/soundbar is connected to the network, software updates will automatically be sent to the product through Wi-Fi or the internet, if available

In the JBL ONE App:
(1) Go to My Products, select your product
(2) Select Support tile
(3) Under General, select Product Support

If you cannot stream music  with AirPlay, use the JBL One App; 
(1) Go to Settings.
(2) Select 3rd Party Service.
(3) Select the Airplay tile.
(4) Select Reset AirPlay.

(1) Select the JBL speaker/soundbar you want to rename
(2) Navigate to the Support tile and select "Rename My Product."
(3) Press the current name and type in the new name
(4) Press SAVE

You can adjust the amount of audio coming from the upfiring speakers by pressing the "ATMOS" button on the Remote control and switch between middle (default), high or low.

There are two steps in the calibration

1. Place the surround speakers beside your seating position and press the CALIBR button on the remote control. Follow the instruction to start the 1st calibration
2. After the 1st calibration done, place the surround speakers in your desired location and press CALIBR on the remote control to start the 2nd calibration

NOTE: Apple IOS users are not able to find their MAC address in Google Home app due to privacy policies in the USA and European market.

We advise setting up your device on a less secure network. Log into the router and retrieve the MAC address for your device then add it to your preferred network.

Instructions below are for Android only

1. Open your Google Home app 
2. Enable Bluetooth  on your device.
3. Enable Location service  on your Android device.
   1. Remember to "Allow" Google Home to view your location while using the app (You are asked during setup of the Google Home app).
   2. In case you denied access go to Settings  Apps  Google Home  Permissions  Allow to view Location.
4. When you at selecting the Wi-Fi network from the list of available networks, before tapping on your network you need to get the MAC address.
   1. Tap  the  located top right corner.
   2. In the pop-up menu press "Show MAC address" Write down the MAC Address.

You can now add the MAC address to your local Wireless router or system if your configuration requires this before installing the device on your network.

Finding the MAC address after speaker is installed

1. Open your Google Home app .
2. Tap on  to view your home.
3. Find your room .
4. In the top right corner tap Settings icon .
5. ​Scroll down to the bottom of the screen. You will see some system information and the MAC address as well.

(1) On the subwoofer's rear panel, press and hold the pairing button until the LED  turns fast, flashing white.
(2) To enter the subwoofer pairing mode on the soundbar, press and hold the bass button on the remote control for more than three seconds. Then, press VOL - on the remote control.

On the soundbar LED display:
→ "SUB PAIRING": The subwoofer is ready for pairing.
→ "SUB PAIRED": The subwoofer is connected.