P462
150-watt, two-way, coaxial 4" speaker
Sold from 2008 until 2013
| Predecessor Product: | POWER P452 |
|---|---|
| Successor Product: | GTO429 |
| Made in: | China |
Documents & Downloads
Product Specifications
- Type
- Two-Way
- Series
- Power Series
- Size
- 4
- Frequency Response
- 75Hz – 23kHz
- Nominal Impedance
- 2 ohms
- Power Handling (Peak)
- 150W
- Power Handling (RMS)
- 50W
- Sensitivity
- (2.83V@1m) 91dB
- Mounting Depth Woofer (mm)
- 47.5
- External Diameter Woofer (in)
- 3-7/8
- External Diameter Woofer (mm)
- 99.2
- Mounting Depth (in)
- 1-7/8
- Mounting Depth Woofer (in)
- 1-7/8
- Mounting Cutout Diameter (mm)
- 99.2
- External Diameter Tweeter (in)
- 1-13/16
- Mounting Cutout Diameter (in)
- 3-7/8
- External Diameter (mm)
- 99.2
- External Diameter (in)
- 3-7/8
- External Diameter Tweeter (mm)
- 51.6
- Mounting Depth (mm)
- 47.5
- Mounting Depth
- 1-7/8 inch
4 inch 2-Way Loudspeaker with Plus One HCL woofer cone and high-bandwidth edge-driven textile dome tweeter
The Plus One® Honeycomb-Laminate™ woofer cone is exceptionally stiff and lightweight with up to 25 percent more active surface area than a standard one of the same size. With long-excursion surrounds, it boosts bass output and efficiency by 2 to 3 decibels compared with others.
It’s not the miniature tweeters that most others use, but a high-bandwidth, edge-driven textile-dome tweeter like those found in very high-end home audio loudspeakers. Crank it up. You get less distortion, even at high volumes and superior integration with the woofer.
You’ll have 50 watts RMS and 150 watts of peak power handling. And push it to the limit. You’ll hear true JBL® sound, with nothing under- or over-emphasized. The P462 has a frequency response of 75Hz to 23kHz.
In addition to better sound quality, the new, proprietary, JBL-patented woofer design offers far higher SPL (sound pressure level) and better suspension symmetry means lower distortion than the previous generation.
These speakers make the best use of any amplifier by providing an optimum 2-ohm load. They use a lower-impedance voice coil than a typical speaker to extract the most power and performance possible from all amplifiers engineered to drive loads of 4 ohms or less.
Outboard crossovers are integrated into a harness connected to each speaker for easy installation. Oversized Direct-Connect terminals ensure perfect connectivity for bare speaker wires.
Images & Videos
