MA 6004
4-Channel Full-Range Marine Amplifier (60x4)
Sold from 2006 until now
| Made in: | China |
|---|
Getting started with your MA 6004
Register your product
Do you own this product? Register it here! And claim your warranty or service easily
Register nowDocuments & Downloads
Product Specifications
- Series
- Marine
- Type
- 4-Channel
- Amplifier Power (RMS)
- 60 watts x 4 channel @ 4 ohms and ≤1% THD + N
- Signal-to-Noise Ratio
- 86dBA (reference 1 watts into 4 ohms)
- Dynamic Power
- 145 watts @ 2 ohms
- Effective Damping Factor
- 6.39 @ 4 ohms
- Frequency Response
- 10Hz – 27kHz (-3dB)
- Maximum Input Signal
- 6.0V
- Input Sensitivity
- MAXIMUM... 100mV
- MSRP U.S.
- $169.95 each
- Input Sensitivity
- 100mV
- Signal-to-Noise Ratio
- 80dBA
- Damping Factor
- 6.395 at 4 ohms
- Dynamic Power Output
- 145W at 2 ohms
- Dimensions
- 2.2 inch x 13 inch x 10.3 inch
4-Channel Full-Range Marine Amplifier with electronic crossover, variable bass bosst and preamp outputs.
With a marinized circuit board, stainless-steel hardware and all the right waterproofing, the MA6004 is, like all JBL® marine audio products, built to survive salt water, corrosion and other risks – and show you a great time out on the water.
The JBL® MA6004 has onboard 12dB electronic crossovers, giving you tuning options for systems of any size. Versatility, convenience and ease of use are all part of the JBL way of sound.
Your boat may give you a choice of where to install your sound system, or it may not. Fortunately, the MA6004’s variable bass-boost circuit provides additional bass tuning to optimize performance, regardless of where it lives.
Owning a boat takes commitment and work. Installing the JBL® MA6004? Not so much. It’s also pretty compact at 13-1/4" x 10-1/4" x 2-3/16" (337mm x 261mm x 56mm) with a low-profile heatsink. You can put it in some very tight spots.
The JBL® MA6004 has output of 60 watts RMS X 4 channels at 4 ohms. You can fill the fresh, open air with great sound.
The MA6004 comes equipped with a separate 12dB Per Octive Electronic Crossover for front and rear channels. This provides a high level of tunablity and allows for different speakers to be connected to the front channels and rear channels. Both crossovers are setep to allow for either high-pass or low-pass.
The front and rear channels are also equipped with a separatae variable bass boost for the front channels and rear channels. There is a total of 6dB of boost available centered at 45Hz.
The MA6004 has a preamp output which allows a full range signal to be passed on to additional amplifiers.
Images & Videos
Can’t find what you’re looking for?
Chat with Us
Mon-Fri 8:00 AM to 5:00 PM (AEST)